Reply To: Hello guys big problem on the way!

[Jonathan]

My advice to you is still to try flashing Android over USB as directed in the guide (the PDF file attached to the first post in the other thread to which I linked). The bit from the guide that you require is this:

Secondly, download the Manufacturing Flash Tool from here: https://drive.google.com/file/d/0B_WhOdPMvW1OY3RTUUlyM3RPVUk/view?usp=sharing
Extract the contents to a folder on your PC. Then install the usb driver (as we have Baytrail devices we only need to install the IntelAndroidDrvSetup 1.5.0.exe but to be honest I installed the other too, just for luck.
Then install the Manufacturing Flash Tool 6.0.51, once complete copy the CUSTOM_CONFIG file to the installation directory of the MFT should be here “C:\Program Files (x86)\Intel\Manufacturing Flash Tool”.
Open the Manufacturing Flash Tool, click “file”, then “setting”. Under SOC devices The VID should be 8087 and the PID should be 0A65. Then under Android devices The VID should be 8087 and the PID should be 09EF. Note: yours could be different, you can get them using device manager when you first enter dnx mode so don’t panic. Then click “apply” and then “ok”.
Next boot into the bios by pressing the power button and when you see the backlight press “escape” click on the bottom right icon to get into the bios properly, navigate to the next tab and select “Android” as the default boot device, press F10 and select “yes”. Note: this ensures that the device identifies the right hardware and also makes it easier to get into “DNX” mode.
Next download the Android image from here:
https://drive.google.com/file/d/0B_WhOdPMvW1OVElJMGp6LXlnSDQ/view?usp=sharing
Extract the image to a folder, then go back to the Manufacturing Flash Tool and click “file” then “open” navigate to the folder you’ve just extracted and select the “flash.xml” file and click “open”. The program should now say it’s ready to flash.
Go to the tablet and hold the power button and volume button (closest the power button) once the screen lights up let go of the power button. You should now get “DNX MODE”, “Waiting for fastboot command”.
Put the USB cable into your main PC then place the micro-usb into the tablets micro-usb port. If you had already been flashing and have the drivers installed, then the flashing procedure will be automatic.
Once the flash is finished it should reboot the tablet, if not as long as the MFT says “Board Flashed Successfully” and your tablet says “OK” use the volume up & down to select “Reboot” then press power.
Wait for Android to fully boot and it will be in Chinese. It’s easy to change if you know Android. Click the obvious setup prompts, then slide your finger down from the top right and click the cog, scroll down and you will see an icon that resembles language & Keyboard, select this then click the top option and scroll down and select your language. You should then set your keyboard and time zone.

The above excerpt is, I believe, written by a user called Phillip by the way, i.e. not my work.