2 in 1s with reversed tablet tent mode – pogo pinout?

2 in 1s with reversed tablet tent mode – pogo pinout?

TechTablets › Forums › General › General Discussion › 2 in 1s with reversed tablet tent mode – pogo pinout?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 26, 2017 at 3:00 am #66070
    murdic
    Participant
    • Posts: 21

    I’ve just bought another 2 in 1 tablet with a magnetically-retained keyboard, this one “tents” with the tablet reversed on the spindle.  It occurs to me that its pogo pins must be “onomatopoeiac”, they work the same in reverse order.  I just grabbed a cube iwork 10 and tried reversing the tablet on its keyboard, it doesn’t work that way.  Does anyone know if there’s any convention on pogo pin order?

    April 28, 2017 at 1:35 pm #66214
    murdic
    Participant
    • Posts: 21

    You’re right – palindromic.  Able was I to think it until I tried to write it…  Not up to anything in particular, I just bought an Onda 2 in 1 that’s the same format as the cube I mentioned, and Onda are pushing “tent” format to stand the device on a table for viewing.  It occurred to me after I framed the question that the Onda might be just like the Cube and be unresponsive to the keyboard when the tablet’s reversed on it, but I won’t know until it arrives.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

Lost Password

Skip to toolbar