NOT working. Erases, reads zero, ok. Flashes, verify fails, and the reason for verify fail is that only the start of the device range gets flashed, then its zero to the end.
Laptoo says nothing, black screen. With original bios or the older one “jumper.rom”.
NOT working. Erases, reads zero, ok. Flashes, verify fails, and the reason for verify fail is that only the start of the device range gets flashed, then its zero to the end. Laptoo says nothing, black screen. With original bios or the older one “jumper.rom”. WTF.
Forget verify, CH programmer fails too. I never cared about it. Just flash and check, if BIOS boots, you can reflashs with same dump file with UEFI prompt, to be sure.
Ps: With CH programmer verify was not ok, but PC-s, tablets booted. Because of that i made UEFI reflash via command line to be sure. But all was other type of chips not that, i do not know for sure, that CH programmer will be OK for that chip, theoretically yes, because it is in the support list.
Got the prommer working! It was connected with parallel cable to pc and swapped it to usb cable. Now flashing and verifying is ok but laptop wont work. Black screen. Then what…
One thing I dont understand… Buffer range of the promming software is up to 7FFFFF but device programming range is FFFFF. And I cant set it to 7FFFFF. Maybe it just flashes up to FFFFF and thats it. Strange…
Yes, should be. Somewhere must be set the range to 7FFFFF. This is the reason why the lapotop not powers up. I never faced dutch problem, just programmed with CH and profit. I do not know this Elnec software.
.
.