Jumper EZbook 3 Pro – Change QWERTY to QWERTZ by Removing the Keyboard Keys

Jumper EZbook 3 Pro – Change QWERTY to QWERTZ by Removing the Keyboard Keys

TechTablets Forums Jumper Discussion EZBook series Jumper EZbook 3 Pro – Change QWERTY to QWERTZ by Removing the Keyboard Keys

This topic contains 3 replies, has 3 voices, and was last updated by  joe321 1 month ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #70443

    Nebular
    Participant
    • Posts: 21

    So i think as a german it will be fine if the Keyboard can just changed by remove the Keys from the Keyboard? (Remove “Y” and “Z” an change the position.)

    Can someone say is it hard to remove the Keys from the keyboard? specialy from Chines Laptops i am not sure. (Apple Macbooks are …fine by removing Keys and something like this).

    Thx and sry for my low budget english.

     

    #70772

    ReeCorDs
    Participant
    • Posts: 1

    Hello,

    it’s possible to change the keys. I also did it with Y and Z because i’m german 😀

    #70773

    Nebular
    Participant
    • Posts: 21

    its easy? because its the same plastic system like other keyboards right?

    #70785

    joe321
    Participant
    • Posts: 22

    I just changed Y and Z on mine … Its similar system  to other laptop keyboards. I raised the right side of the key until I heard 1 click, than I raised the top and after second click the key comes off. Fitting back is done by pressing down the key until you hear clicks.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

Lost Password