Teclast Air III 64gb Dual Boot Model: M5C6 – Something has gone very wrong!

Teclast Air III 64gb Dual Boot Model: M5C6 – Something has gone very wrong!

TechTablets › Forums › Teclast Forums › X98 Air 3G / Air II – Single and dual boot › Teclast Air III 64gb Dual Boot Model: M5C6 – Something has gone very wrong!

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 7, 2015 at 9:47 pm #17886
    Nathan
    Participant
    • Posts: 3

    Right, been doing some digging and any suggestions people can make (and I sincerely hope there are some!) just note: adb does not detect the tablet at all.  And no, I wasn’t able to put the device into Developer mode because I can’t even get past the bootloader at the start.

    Been reading some bits around though, and is this an issue with a faulty eMMC?

    December 10, 2015 at 4:48 pm #18126
    RICK DAVIS
    Participant
    • Posts: 1

    Had the very same thing happen to my Pipo W4S! I have not found anything to rectify this 🙁

    December 20, 2015 at 12:33 pm #19289
    Jonas
    Participant
    • Posts: 1

    Hey Nathan, which advise did you receive? Because I have exactly the same problem: Windows 10 and Android, stuck at Teclast Logo after updating BIOS to 2.20 ;(

    But with me, the DNX mode is working, so I can output adb commands to the tablet.

    So I will need to reinstall the BIOS I guess..

    Thanks in advance!

     

    December 23, 2015 at 9:02 am #19634
    Arthur
    Participant
    • Posts: 3

    Did anyone of you manage to find a solution? 🙁 I’m stuck with the same problem too

    January 11, 2016 at 6:12 pm #21927
    Zsolt Tóth
    Participant
    • Posts: 9

    See on xda – X98 troubleshooting topics – BIOS restore/unbrick

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.

Lost Password

Skip to toolbar