TechTablets › Forums › Teclast Forums › General Discussion › Teclast x16 Power – format and install Windows 10 Pro
- This topic has 3 replies, 4 voices, and was last updated 10 years, 4 months ago by
ศิวกรณ์ บุญเกิด.
-
AuthorPosts
-
January 3, 2016 at 8:07 pm #21117
we found installed android and windows were too buggy and slow. a lot of lockups and restarts, bloated malware and especially windows home version is limited.
so we had to format everything and install fresh windows 10 pro image.downloaded original microsoft iso image from here -> W10Pro x64
also we backup all drivers from current install with DoubleDriver and saved to another usb stick. also copy TouchSetting.gt from C:/Windows/inf/
to create proper usb drive with iso image we used this software http://rufus.akeo.ie/ with:
– GPT partition for UEFI
– FAT32
– 4096 bytesthe only problem we could not boot from USB.
so we went another way:
in case if you dont see usb drive, enable in BIOS fast boot with usb full availability,
then go to windows ->settings -> recovery
and press “Restart now”.
you can plug in USB with windows installation image.
it will load then engineering menu, find in menu and press “Command Prompt”.
after entering your account password and entering to command prompt.
dont forget that you will have to use mouse and keyboard.
enter USB drive letter and type setup.exe, and press enter.windows setup will start.
deleted all partitions and created one single 59Gb partition for installation.not sure if there is any better way, but this one the only working for us.
installed ok. after you login to windows you need to copy TouchSetting.gt to C:/Windows/inf/
and restore all drivers with DoubleDriver, and reboot again.
all hardware will function!
then enabled windows update.
downloaded many windows updates.works very fast, no lags and no Chinese malware.
January 9, 2016 at 12:15 am #21610I’m going to install Windows home when it gets here. Do I have to do it the way you mentioned or can I do it from Windows and use a newer US version. Also I keep reading a lot of info on the touch driver on how to setup on the fresh install. Other than placing the driver in the directory there’s another step to enable, can you confirm this?
January 17, 2016 at 8:22 pm #22778Hi.
I format and install only windows 10 with this method and all OK.
But I not install the cameras.
Use my drivers backup but no install cameras.
Any solution?
March 18, 2016 at 5:06 pm #29933me too
i want use camera after reinstall -
AuthorPosts
- You must be logged in to reply to this topic.

