Unable to boot from Windows USB (EZB3P V4)

Unable to boot from Windows USB (EZB3P V4)

TechTablets › Forums › Jumper Discussion › EZBook series › Unable to boot from Windows USB (EZB3P V4)

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 2, 2017 at 6:21 pm #72925
    metaphore187
    Participant
    • Posts: 2

    Hi

    Recieved my EZBook today, created a windows recovery USB and went about formatting my eMMC ready to install windows on my SSD.

    However I’m now unable to boot from the USB, when I turn the laptop on it enters the EFI Shell and from there I can get to the BIOS but there is no option to boot from the USB drive.

    grateful for any help offered!

     

     

    October 3, 2017 at 7:44 pm #72969
    sipart
    Participant
    • Posts: 42

    Hi, press F7  a couple of times when powering on the laptop from cold and when the Jumper screen is on – this should bring up the boot device menu and your USB should be in that menu if its setup right.

    Cheers

    October 4, 2017 at 2:55 pm #72982
    metaphore187
    Participant
    • Posts: 2

    Thanks, turns out I somehow (still not quite sure how) managed to format my recovery USB while formatting the eMMC. So was absolutely fine once I sorted that! Which is lucky as I was convinced I’d bricked it!

    Cheers

     

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.

Lost Password

Skip to toolbar