Max Barfuß

Max Barfuß

Forum Replies Created

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • December 22, 2016 at 9:34 am #59079
    Max Barfuß
    Participant
    • Posts: 9

    I sold it to a buddy because I wanted 11,6 inch instead of 10 inch. Now I have Teclast X16 Pro

    December 21, 2016 at 10:00 pm #59049
    Max Barfuß
    Participant
    • Posts: 9

    I can not try this anymore. I have another tablet now. Sorry

    December 14, 2016 at 10:22 am #58603
    Max Barfuß
    Participant
    • Posts: 9

    It is not important what source you use for win 10 installation.Important is to find the teclast driver package for the tablet.Right after Win 10 installation you will have to work with mouse and tastatur until you have installed the driver because you need the driver for the touchscreen too to use the touch

    October 30, 2016 at 4:29 pm #56125
    Max Barfuß
    Participant
    • Posts: 9

    I suppose you have had an activated Win 10 on it before. If this is the same version then before, Microsoft will recognize and activate it again immediately because MS creates a unique Key based on some of the components of the machine

    October 30, 2016 at 10:35 am #56104
    Max Barfuß
    Participant
    • Posts: 9

    Hi Daniel, the short answer is, you can after start the windows installation choose to delete all partitions until you have only unallocated space on the drive. Then you can go on to install windows or to abort to leave the drivespace unallocated.

    The long answer is:

    I created a bootable Win 10 install USB-Stick. Before that I bought a “active OTG USB-Hub” (Good experience I have with one from Brand “Inateck”. Then you connect the USB-Drive and at least a mouse to the Hub (because you cannot use the touch after install windows, you have to install the driver package for the tablet  first. I found the link to that package here in the forum)

    OK, all connected ? Now  start the tablet by pressing and hold more then 10 seconds the power and the volume up key together. Now you are in the BIOS/UEFI. Now you can go in the UEFI to “Boot override” and choose the USB-Stick to boot from.
    The next steps can you see on the top at the short answer.
    Sorry my english is quite poor.
    Hope it works for you

    Didi

    September 27, 2016 at 4:41 pm #51020
    Max Barfuß
    Participant
    • Posts: 9

    Thx Veaceslav this will help me a lot for my own tries ???

    September 27, 2016 at 6:06 am #50887
    Max Barfuß
    Participant
    • Posts: 9

    Hi Golden, thx for your experience and your tips. If I do so too do I need special wire or can I reach better performane with usual isolated copper wire.

    Thx again

    Max

    September 22, 2016 at 1:37 pm #50419
    Max Barfuß
    Participant
    • Posts: 9

    Thank you very much the hint with the menu in the upper left corner was the solution for me. Sometimes one cannot see the tree in the wood 🙂

    I don´t need it right now but is there a possibility to activate this again too?

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)

Lost Password

Skip to toolbar