[Ignacio]

Is to enter DNX mode.
No problem of “Manufacuring flah Tools” because I can not get to use.

To use the “Flash Tools Manufacturatin” You need to turn on the tablet with “Vol +, VOL- and power” and when you do a text will appear (I guess that’s the DNX mode).

When this text appears you have to connect the tablet to the PC with the “manufacuration Flash Tools”.

I would not that text appears. When I press (Vol +, VOL- and power) appears me “BOM selection switch (SW1B1) Have you changed FORCE_WINDOWS / BOM3 1 mode”. This error is 3 seconds and then start Windows.

[Ignacio]

Yes, I runned this .bat in Widnows. And If I’ve enabled or disabled the fastboot the text is the same. I don’t undersand.

I tried to reinstall the “dualboot bios tested C6J6 and C8J7” repeatedly, but the result is the same.

Could be the version of the tablet the problem? My tablet is C6J7 and the dualboot bios tested is tested in C6J6 and C8J7.

[Ignacio]

Thanks for you response.
I looked the BIOS and yes, the fastboot was disabled t, but I’ve activated and when i turn on the tablet with vol + vol – and power, I can see the same text.

I tried to activate all opcions of fastboot too. But the result has been the same. :S

[Ignacio]

When I press Vol+, Vol- and Power and hold, we can see the error BOM selection switch (SW1B1) has changed FORCE_WINDOWS / BOM3 1 mode. The system will load relative setup setting and reset in three second).

This message appear if I have installed “DualBoot Bios C6J6 Tested And C8J7” If I install the only windows bios for C6J7 I can see other message.

[Author]

Posts