[seyon]

Sir, I want it ( on 1st october 2020) the link is not working

Could you provide me correct one

[seyon]

sir from the drivers you have provided touch screen not working . i have put excess files from my oldinstallation sytem/32/drivers then touchscreen worked

[seyon]

windows 10 that was preinstalled on jumper 5se is a windows 10 home version . Actually key is writed in motherboard ( uefi )
so if you install windows 10 home version that will not ask you a product key .

 

if you install a pro version you need to buy pro version licence
and just try to repair your previous installation .
if you try to format and fresh install again you need drivers
this website has provided drivers but but you should know how to install them
but by the drivers this website provided touch screen wont work
you have to put a lot  all  old (c:\windows\sytem32\drivers) files to new installation system 32 drivers folder
( this site dont have them ) i have them if you need i can provide

 

use bampoo smart
pen is working fine with anniversary home version (not working well with latest builds )

good luck

[seyon]

that is great

[seyon]

surelly full video and all the drivers i will provide . i have some practicals next two days i will be doing that with in 3 days

[seyon]

i can make it with in 3  days and post it dont worry

i also did had the same problem finding installation

my touch screen dint work after fresh instalation etc

 

[seyon]

its soldered on board

[seyon]

you need a drivers backup and sytem32/drivers folder backup beforeany fresh install so just repair it

[seyon]

you can usb boot this device

create a uefi win 10 usb disk ( https://www.youtube.com/watch?v=FzVHxevBw2E  )

on the start press esc / or press volume up and power on device

after some seconds bios will open go to boot options

then you can find your usb under

uefi disk ( your usb name)

that will be the second options thats all then go to setup and repair windows

[seyon]

in windows 10 go to control panel and select option – backup and restore ( windows 7 )     –

and choose image backup -we need and external usb harddrive for this purpose

you can restore this image by a windows 10 installation usb

connect install usb in 3.0 port and back up usb in other port go to win 10 setup and select repair

there you can find an option to restore from system image

 

[seyon]

thank you

[seyon]

oh sorry

i didn’t write usb as uefi earlier

what i have corrected is i did use rufus

i did select [ MBR partition scheme for UEFI ]    from   [partion scheme and target system type ]

( 2nd drop down menu in Rufus )

now all ok

thank you nicolas

[seyon]

( checked again ) yes i have tried it on hp 2740p it recognize it and booting in to usb , thank you

[seyon]

i made usb with rufus

i cant find that option please can you upload a screen shot

i did press escape and went in but under boot otions

1 efi boot devices – grayed out

2 windows boot menu

3 efi command prompt – there also i cant find my usb

fs0:

pl0:

 

have eufi but both loading to installed windows

[seyon]

i cant find a boot menu

[Author]

Posts