-
Aryan csz replied to the topic Ezpad 6 pro Battery problem in the forum EZPad series 6 years, 11 months ago
Probably I should only reply for this…
After going through lot of circuit analysis
I connected 12V bulb to discharge battery to recharge it. Balancing circuit had a issue of mischarged…. so after draining battry 12v bulb for 3 to 4min I removed it and checked via multimeter
Whaola… its reset to zero now the voltage is 8.4 volts which d…[Read more]
-
Aryan csz replied to the topic Ezpad 6 pro Battery problem in the forum EZPad series 6 years, 11 months ago
Guys I request someone to disconnect the battery (from board) measure the black to red voltage across connector note the voltage
And Black to Yellow (Res) note the resistance and send me…
Recommend to test it when battry is below 10% please do send me awaiting
-
Aryan csz replied to the topic Ezpad 6 pro Battery problem in the forum EZPad series 6 years, 11 months ago
I have tested cell cell they are working fine.. both batteries…. but there is problem with the protection circuit…. I don’t know how to troubleshoot it.
-
Aryan csz replied to the topic Ezpad 6 pro, power on with battery, help! in the forum EZPad series 6 years, 11 months ago
Yes
-
Aryan csz replied to the topic Ezpad 6 pro Battery problem in the forum EZPad series 6 years, 11 months ago
Thank you… 😊
Yeah the connector is same as you shown above… and the readings as I mentioned before its showing 3.7volts with both RED to Black Wire on multimeter…. and 6.7k of resistance block and yellow wires….
As you said I’m ready to diagnose it… by removing the battery tape and measure the voltage of each battery….
And I…[Read more]

