[tonpitonpi ton pi]

Never for games, read pdf, youtuve, films o web,  and y use greenify for automatic close app, and no frills cpu to set cpu velocity no more 1,2 ghz and low brightness. From new. I have to open and check temperature of  battery in charge, for check both  battery charge each equally.

[tonpitonpi ton pi]

hi , teclast x98 pro have  a 8000 mah battery, 30400 mwh (3,8V) the duration is about 2-3 hour, my and other people,since beginnig, and little use. If  you have more duration tell me.  With a usb tester  the current of charge is about 2A  for 2 hours (4000 mah). This is half capacity, have one of the two battery bad  ……?????? . With charge at 100%, the current is 1,5 amperes, 0,9 if close services. I buy in ebay and waiting  other usb tester with capacity tester. Have you check the real capacity of the batterys ???? Other posibility is desolder wires of battery and  charger  with external, and check the capacity. The current of charger is determined  by un resistor next to the monolithic switching charger, if the new battery  is really more capacity, the difference is more time   for charge full.  Be careful with chinese capacity,  a lot of are counterfait.

Attachments:

You must be logged in to view attached files.

[tonpitonpi ton pi]

Yes, TECLAST Android  does not support NTFS, that only half of problem,  branch or  type, is the  other, my kingston  run ok(Class 4), but two trancend (class10) no. The kingston formated in NTFS can read, I can see  a film, but no erase a file.  This errors, is tipical from cheaper dispositives.   My old pda acer N30, had that problem,  if  a sd card  not run, buy another diferent. I have a  music tower? with  mp3  and the same problem.  A friend with a teclast 98 plus, the same problem, buy the last  sd samsung by amazon,  a last week after,  dont run in android, he actualized the bios ,  and now  run all micro sd.

[tonpitonpi ton pi]

In slow charge,  if the table is runnig,  don´t charge,  discharge slow , because the current    is not enough,  and a part is supplied from the battery.

For a normal charge (fast )  you need four wires , and made a messy conections.

[tonpitonpi ton pi]

hi , I made that in laptop, for repair  the dc jack,  when was imposible repair  pc board,  or to attach   in the inside, for the same reason.  By the other,  my teclast x98 pro,  the current  in charging  is 2.2 amperes,  is a lot of for a  micro usb , and is easy  to burn in summer.   You need  to weld to wire  near  micro usb,, pin of micro usb are very small, is dificult,  remember for  2.2 amperes   we ware with the diameter of wires,  find in internet  which one is the pin – and +, test with a volmeter for more security, made a hole  in the back, tie the wires , and add dc jack in the outside.  This is easy, we have a  slow charger,  0.5 0.8 amperes no more.   The reason is,  teclast charger and  other  very good charger send by the two data pines a  preconfigured  voltage,difernent in the pins,  and the tablet, phone, made  a slow o fast charge,  also check teclast, voltage, you have  a power  charger, but  wire is thin, charger of my phone,  the voltage  is below 5 v,  the current 1.1 amperes ande the wire is burn.

[Author]

Posts