[Kunc]

Okay, let me check the media driver. I have installed all drivers in the driver folder downloaded from techtablets for i7 book, but let me check again about the media driver you mentioned. Thanks.

[Kunc]

hi Guys!!

 

So, i had no luck with the cloning attempts, both using Macrium or the one you suggest failed with different symptoms (the macrium caused the driver for camera worked poorly, wifi and bluetooth didnt work), the other made the startup failed.

So, i tried a fresh install of Windows 10, and ended up with pretty good result. My Cube i7 book works fine now. But one other problem happened, the camera is not working.

Have checked to the thread mentioned above, but seems mine has different problem cause the two Control Logic drivers are in the same version as required in the thread solution.

So, don’t know what to do know cause every single driver already installed with success message on each installation.

 

Btw, the way i cloned using macrium and the other one was something like this:

1. Start up Cube i7 windows, and install the cloning software.
2. Start the cloning software and make clone of the drive C (which is in cube i7 should copy everything, including the system, recovery and the other partition)
3. Dismount the old SSD and mount the new one (the bigger one with cloned windows from previous SSD)
4. Start the Windows, and…..
   1. Macrium –> windtab32.dll error at logging in, camera wifi bluetooth not working
   2. Aomei –> Going to the Repair windows screen, and couldnot do anythin
5. So decided to put back the old SSD

 

Okay, forget what i’ve done with the cloning,. anyone help me with the camera please…

[Kunc]

Thanks God the problem is not the hardware, cause after put the old SSD back and start, everything was just fine.

Let me try the tool you recommend and get back to you once done.

Thanks a lot mate!!

[Kunc]

I clone it using macrium reflect software..

I think the camera problem is not about the driver as the one in my cube is still the same version

[Kunc]

Hi,

I just upgraded my Cube i7 Book SSD to larger capacity, and already completed cloning the previous SSD to new SSD using Macrium Reflect software.
But i got problem, when i tried to start it up, found out the screen went black and a message like listing all the drive block number etc and the bottom of it was prompt to choose whether skipping startup.nsh or continue something.
Unfortunately, i don’t buy the bundled keyboard, as i planned to use bluetooth keyboard (just want to be more handy). Is there anyway i can do to startup the Windows 10?

Thanks a lot.

[Author]

Posts