[Kyriakos]

I had to do a clean install because reset got stuck at 26% and then I got an error when I forced a reset.

For me camera driver wasnt signed and it was not installed. You have to restart windows with a special way to let it be installed.  Check here http://techtablets.com/forum/topic/two-problems-after-a-clean-install/

You could also try the drivers another friend suggested after my question.

[Kyriakos]

http://techtablets.com/wpfb-file/double_driver_4-1-0_portable-zip/

and drivers: http://techtablets.com/downloads-drivers-roms/

[Kyriakos]

David wrote:

I use this drivers and all works perfectly https://mega.nz/#!FsxiRQ5Q!r0aHnWabQK-h7DsbRoaUNm6ZiCvYYc464UerSPOkGHY

 

Interesting pack… But it needs better knowledge to manually do the procedure. (Double driver is easier) I’ll try it! 🙂 THank you! Maybe we could add this RAR in the forum of TECLAST x98 plus

[Kyriakos]

A good friend gave me this solution which worked:

Type in Command Prompt (as admin)

bcdedit.exe -set loadoptions DDISABLE_INTEGRITY_CHECKS

(enter)

bcdedit.exe -set TESTSIGNING ON

It worked. In the bottom right corner is says “TEST MODE”…

[Kyriakos]

Hi! I have also a problem with the camera after a clean install. It wasn’t installed with the double driver and the packet of drivers downloaded from the forum because of an error. I found out that it doesnt have a digital signature. So I installed it with the procedure of special restart successfully [“Disable driver signature enforcement”]. It worked! BUT when I restart normally,  windows block again the driver and camera is off. What can I do?

I recovered the system with the tablets recover partion and then used the drivers packets found it forum.

Everything else is fine. Except an error in device manager for ‘Microsoft Virtual Wifi miniport Adapter-11″ but this is not affecting anything.

Thank you all!
Kyriakos

[Author]

Posts