from which country did you sent it to china? Could you tell me more about the process? And where to get this firmware from?

hi, Unfortunately the problem with my iWork 11 was the main memory chip. It was sent to China and repaired.

It came back fully installed.

I have however, managed to fully clear and install my small Onda tablet.

The process may well be similar.

I attach the word document to provide guide lines only.

You will still need all the correct firmware…[Read more]

hello adramel and xeun. I have Cube Iwork 11 i8t Could you please help me here, I am able to access bios but unable to install windows as it is showing unallocated space of 8Gb and no other space. I am unable to create a partition

could you please guide me here.

[email protected]

please contact me.. need help

Thanks Werner. Would you let me know which clonezilla  you used before?

You’re right. Looks like he can’t find the paths. You can just try a different version of clonezilla or ask someone else for advice. Unfortunately, I can no longer help you here.

Good luck!

feel regret I did not know this before I read your article! krunker

Great post! I didn’t knowral of these resources and I’m going to go check them out now! friday night funkin

I had the same issue and the problem was that the boot loader was not working in a E6N1. I could find a tutorial to reinstall it, but it was a couple of years ago and I don’t have the link.

“sudo  mkroot.sh ” i have tried, you can see that at the above picture at the bottom command line. still not success.  Seems can not create directory and find the superuser.apk.

Read Page 1 and do not stop at Blondak’s description. It’s not that much.

I have read and followed. Make a Clonezilla boot USB drive,  and put mkroot folder inside, success boot and enter to the command page.

the problem is i follow the steps, but septs of  enter sh mkroot.sh the process is not succeed as the following picture. what can i do next?

You have to be superuser. Read the whole page 1 of this topic from the beginning and follow the steps one by one.

I have followed the steps, but seems still can not root. The problem is  when enter su mkroot.sh the process is not succeed.

What can i do next?, Please check is there i am wrong the steps.

The following Pic is my result when type  su mkroot.sh

Blondak attached it in Post #4.

Where can download the mkroot.zip

Do you guys also print a lot? I did not notice that until I bought a printer. Now I can find a hundred reasons to print something. It can be some paper for work or something for my kids. It is like a new game to me. Fortunately, I can buy cheap cartridges at https://www.mrdepot.ca/products/hp-laserjet-1020-toner and not worry about it.

for the original firmware just go to : https://www.teclast.com/en/firmware/

Type g4m8 for the X4 model and you will see drivers and original image

Thank you for those links 🙂

Hi guys if you used these strings;

W16 0xFED170A8 0000

W16 0xFED170AC 0000

WRMSR 0x610 0x0 0x00000000 0

and stıll not get 700mhz on igpu  try to increase pp0 current limit on ThrottleStop

<span class=”VIiyi” lang=”en”><span class=”JLqJ4b ChMk0b” data-language-for-alternatives=”en” data-language-to-translate-into=”hi” data-phrase-index=”8″>I found my solution on online mic test.</span> <span class=”JLqJ4b ChMk0b” data-language-for-alternatives=”en” data-language-to-translate-into=”hi” data-phrase-index=”9″>This website has been very…[Read more]