thanks for the info dear. All the info you shared is very interesting.

marketing automation software

Again I ran into blue screen issue .. I will check what I installed the last days ..

could you please re-upload it? Too many people downloaded the file, it’s blocked. unfortunately the image bmax has up, it somehow a corrupt z02. 🙁

Did you try rebooting after connecting the hub? I remember doing that to make the X98 ‘see’ its OTG.

I tried to download the 4 files found on this website in the download section. Unpacked all files to USB stick, checked it on another PC but X98 Pro is not starting up from this USB stick due to the fact that the OTG port and USB hub (external powered) don’t recognize any external device.

Pfffffff…….

Please help!

The system is clean installed succesfull. After reboot the system is asking for a login password, but because of the screen driver the screen is reversed. I tried to load the driver, but none of the interfaces are working. The OTG port is not working. The USB Hub attached to the OTG port is not working. The external USB port is not working. The…[Read more]

Thank you for advice

I had the same problem

so i got the bmax y13 n4120 and my model PN says its H2M6, so i went to the website and it shows 2 drivers, one for the Touch pen 2.0 and another for a firmware 2.0 but there’s no download button on both

AFAIK the N4100 version doesn’t, see Chris’review, but according to the specs the N4120 refresh does (unconfirmed though).

It’s just what I try to do… let it discharge and poweron again

But there is 4 days that when I try to poweron it is still charged 🙂

Anyway I don’t think I was hacked.

Thanks for the help.

Denis

@denisj You’ve been hacked by chinese hackers! They watch you over the internet through your tablet’s camera!

In all seriousness though, you should let your tablet discharge completely, then charge it again and see if it works.

Good luck!

Nobody can help me please ?

he unbrick hi 13? procedure from hi 10 and hi 12 will be work?

this method work on hi 13?

Will be work on chuwi hi 13?

Thanks for sharing man!Really appreciate it!

Unfortunately it didn’t work, suborn igpu all that power end still 450 Mhz 😛